Simpson 270 Series 4RT

Analog - VOM

Volt-Ohm-Milliammeter

This Simpson 270 Series 4 has the 00248 Roll Top Case option.

 The Simpson 270-4RT has the Taut Band Suspension and a mirrored dial to eliminate parallax errors.

The 270 Series 4RT has the three Amp-Clamp scales.

Controls include: Ohms zero adjustment, AC - DC - Select, a 12 position Function / Range

selector switch, and eight recessed probe jacks.

The off or "transit" position is at the 500 MA position on the function switch.

Access to battery / fuse compartment requires the removal of the two small screws on the

side panels, the entire back slides out leaving the sides and front intact.

More inside views linked below.

This photograph shows the locations of the fuse and batteries in the back of the meter.

The 1 1/2 Volt "D" cell is used to power the R X 1 and R X 100 Ohms ranges.

The 9 Volt battery is used to power the R X 10,000 Ohms range and the overload circuits.

The batteries can be accessed through a removable cover on the back with a coin-slot screw.

The back cover of the Roll Top Case must be removed first.

Roll Top Case Size: 9 " x 6 " x 4 "   -  Weight: 5 Pounds

Simpson 270-4RT Specifications

DC VOLTAGE

Ranges 250mV, 1V, 2.5V, 10V, 50V, 250V, 500V, 1000V

AC VOLTAGE

Ranges 250mV, 1V, 2.5V, 10V, 25V, 50V, 250V, 500V, 1000V

Rated Circuit-To-Ground Voltage 1000V (AC or DC) max.

DECIBEL

5 Ranges -20 to +50dB * Reference 0dB= 1mW into 600Ω

DC CURRENT

Ranges 50μA, 1mA, 10mA, l00mA, 500mA, 10A

Voltage Drop: (Nominal) 250mV on 50μA , 1mA; 255mV on 10mA , 10A; 300mV on 100mA, 500mV on 500mA

RESISTANCE

Ranges Rx 1, Rx 100, Rx 10K

Maximum Indication 0-2KΩ, 0-200Ω, 0-20MΩ

Back To Downloads                                                      Back To Main Page